Low Power Wireless: 6LoWPAN, IEEE802.15.4 and the Raspberry Pi

What's My Server's Address?

So imagine you've now got 1,000 of these sensors scattered out in the wild somewhere, and they are all running IPv6 servers. What are their addresses? How do you talk to them? Unfortunately, the OpenLabs module generates a new MAC address each time it is booted, so it generates a new IPv6 address each time. Running multi-cast discovery is not recommended for these low power networks as it is a power drain. I will cheat a bit in the next article, but show better ways in the third article.


The scenario presented in the last section is still a bit unrealistic. If you have enough power to drive an RPi as a sensor, you probably have enough power for it to use Wi-Fi or Ethernet. But soon there will be genuine low power sensors using 6LoWPAN, and this article has shown you how to bring them into one particular Linux system. It's been pretty heavy going, but right now this is cutting-edge stuff, so expect to bleed a bit!

In my next article, I'll describe how to bring a 6LoWPAN network into the standard IPv6 world, and in the third article, I plan to look at CoAP, the equivalent of HTTP for low power networks.


OpenLabs Raspberry Pi 802.15.4 Radio

Python API: socket — Low-level networking interface

IETF RFC4944: Transmission of IPv6 Packets over IEEE 802.15.4 Networks (6LoWPAN)

6LoWPAN: The Wireless Embedded Internet by Zach Shelby, Wiley 2009

Create a generic Raspbian image with 6LoWPAN support by Sebastian Meiling


Jan Newmarch has written many books and papers about software engineering, network programming, user interfaces and artificial intelligence, and he is currently digging into the IoT.