SMP and Embedded Real Time
I hope I have convinced you that the -rt patchset greatly advances Linux's parallel real-time capabilities, and that Linux is quickly becoming capable of supporting the parallel real-time applications that are appearing in embedded environments. Parallel real-time programming is decidedly nontrivial. In fact, many exciting challenges lie ahead in this field, but it is far from impossible.
But there are a number of real-time operating systems, and a few even provide some SMP support. What is special about real-time Linux?
To test the fifth and final myth, and to show just what is special about real-time Linux, let's first outline the -rt patchset's place in the real-time pantheon.
The -rt patchset turns Linux into an extremely capable real-time system. Is Linux suited to all purposes? The answer is clearly no, as can be seen from Figure 14. With the -rt patchset, Linux can achieve scheduling latencies down to a few tens of microseconds—an impressive feat, to be sure, but some applications need even more. Systems with very tight hand-coded assembly-language loops might achieve sub-microsecond response times, at which point memory and I/O-system latencies loom large. Below this point comes the realm of special-purpose digital hardware, and below that the realm of analog microwave and photonics devices.
However, Linux's emerging real-time capabilities are sufficient for the vast majority of real-time applications. Furthermore, Linux brings other strengths to the real-time table, including full POSIX semantics, a complete set of both open-source and proprietary applications, a high degree of configurability, and a vibrant and productive community.
In addition, real-time Linux forges a bond between the real-time and enterprise communities. This bond will become tighter as enterprise applications face increasing real-time requirements. These requirements are already upon us—for example, Web retailers find that they lose customers when response times extend beyond a few seconds. A few seconds might seem like a long time, but not when you 1) subtract off typical Internet round-trip times and 2) divide by an increasingly large numbers of layers, including firewalls, IP load levelers, Web servers, Web-application servers, XML accelerators and database servers—across multiple organizations. The required per-machine response times fall firmly into real-time territory.
Web 2.0 mashups will only increase the pressure on per-machine latencies, because such mashups must gather information from multiple Web sites, so that the slowest site controls the overall response time. This pressure will be most severe in cases when information gathered from one site is used to query other sites, thus serializing the latencies.
We are witnessing nothing less than the birth of a new kind of real time: enterprise real time. What exactly is enterprise real time? Enterprise real time is defined by developer and user requirements, as might be obtained from the real-time questions listed in the discussion of Myth 3. Some of these requirements would specify latencies and guarantees (hard or soft) for various operations, while others would surround the ecosystem, where real-time Linux's rich array of capabilities, environments, applications and supported hardware really shine.
Of course, even the rich real-time-Linux ecosystem cannot completely remove the need for special-purpose hardware and software. However, the birth of enterprise real time will provide a new-found ability to share software between embedded and enterprise systems. Such sharing will greatly enrich both environments.
Impressive as it is, real-time Linux with the -rt patchset focuses primarily on user-process scheduling and interprocess communication. Perhaps the future holds real-time protocol stacks or filesystems, and perhaps also greater non-real-time performance and scalability while still maintaining real-time response, allowing electrical power to be conserved by consolidating real-time and non-real-time workloads onto a single system.
However, real-time applications and environments are just starting to appear on Linux, both from proprietary vendors and F/OSS communities. For example, existing real-time Java environments require that real-time programs avoid the garbage collector, making it impossible to use Java's standard runtime libraries. IBM recently announced a Java JVM that meets real-time deadlines even when the garbage collector is running, allowing real-time code to use standard libraries. This JVM is expected to ease coding of real-time systems greatly and to ease conversion of older real-time applications using special-purpose languages, such as ADA.
In addition, there are real-time audio systems, SIP servers and object brokers, but much work remains to provide a full set of real-time Web servers, Web application servers, database kernels and so on. Real-time applications and environments are still few and far between.
I very much look forward to participating in—and making use of—the increasing SMP-real-time capability supported by everyday computing devices!
- Readers' Choice Awards 2014 Poll
- ebook2cw-E-book to Morse Code Conversion
- Overlay Images on Video Using MPlayer and MEncoder
- HEC Montréal: Deployment of a Large-Scale Mail Installation
- Memory Ordering in Modern Microprocessors, Part I
- Using Django and MongoDB to Build a Blog
- Source Code Scanners for Better Code
- RSS Feeds
- Kernel Korner - Why and How to Use Netlink Socket
- KDE Codes Conduct, Working Group, and Fiduciary Duty